We are ready to announce that Esmil Corp., together with our local representative Envirotect, have installed one of the largest machines in the model range, namely, MDQ-353 C at the wastewater treatment plant of one of the leading cheese manufacturers in Ohio State. Specialists of Esmil Corp. have developed a technological solution for the disposal of sludge on the basis of a Multi-disk screw press that allowed to reduce the customer’s operating costs for sludge utilization.
Prior the equipment installation Esmil made full scale excess sludge dewatering pilot test using MDQ screw press MDQ-201. Achieved results were very successful so Ekoton offered MDQ 353 C and installation platform. Also, important factors influencing the choice of Esmil Corp. as a supplier of equipment were the optimal combination of operating costs (polymer consumption, spare parts, energy consumption, labor, etc.), capital costs as well as the guarantees provided.
During the December of 2018, Esmil shipped MDQ-353 C Multi-disk Screw Press. In addition to a challenging installation location, contractor has made custom floor, plumbing, conduit and wire. We took responsibility for the provided technological solution and its implementation “turnkey”.
Project Data
Type of sludge | Excess activated sludge |
Initial sludge supply | 50 gpm 500 lbDS/h |
Operation time | 8 h/d |
Feed Sludge DS Concentration | 2% |
Cake DS Concentration | 16% |
Average Polymer Dose | 22lb/ton DS |